Single-colored candles are beautiful and graceful. A multi-colored candle is different, exciting and alive. How about seasonal colored candles? Do you have a multi-colored table runners favorite? Take a candle of different colors that match the colors of the riders. These candles look like they are hard to do, but are not real, if you follow these simple steps.
Software
Wax candle
Candle
Stearic acid additive
Primed wicks
3 different colors candle dye
Fragrance(Optional)
Hardware
Scissors
Pencil or wicking August
Thermometer
Double boiler
Kitchen scale
Refrigerator or freezer
Step 1: Prepare the mold candle
Place the bar through the base of the mold on a thumb. Seal the end of the mold with mold seal. Vertical Re-form, so that the open end is up. Wicking insert a needle, pencil, pen, wooden dowels, etc., at the opening of the mold and tie the wick. Center the wick as far as possible.You do not want the wick to one side of the mold candle, the candle burns, on this page.
Step 2: Prepare the wax
Working with wax candles enough chips to fill out the form, are divided into three equal parts. Share stearic into three equal parts.
Step 3: Melt a lot of wax
Heat the water bath with a bunch of stearic candle color dye. Once the liquid dye and stearic add the melted candle wax and chipmore.
Step 4: Pour the melted wax
Pour the melted wax into the mold. Be careful not to wax and not the bad luck to get to you. While pouring the wax, do not want to face the pages of the form, because they affect the next layer of color.
Step 5: The cooling time between layers
While the wax, clean the cooling, the double-boiler. Any wax residue from the previous merger will affect the color of the next game. Let the wax inForm, allow to cool until it has formed a skin or film over the top. The core issue is still fluid, but the outside has cooled enough to solidify. The layer should be firm is not sufficient to completely dissolve when the next layer is cast on it.
Step 6: Repeat for the remaining layers
Repeat steps 3 through 5 for the remaining layers. Use the same scent and a different color.
Step 7: Cool the Candle
Place the candle and mold in the freezer for about thirtyMinutes. This hardens the outside. The interior is still fluid for several hours.
Step 8: De-forma
Remove the spark plug and mold from the freezer. Remove the pin wick. Let the candle from the mold. Let stand overnight to cool completely and harden all the wax.
You have the candles, where the layers of color to run in one corner, the candle? To achieve this the same thing, you need the candle mold in a corner, while all positionlayers are expressed with the exception of the last layer. The steeper the angle, the stronger they are from one corner of the layers. Before adding the last layer to set the form so that the base of the candle will be level.
Related : Baby Cradles - Choose a safe baby cradle for your way to buy the best Gps systems you can find more best about Panasonic lumix and Lumix DMC-FZ35 find save about Slide Scanner,wireless headphones and garmin nuvi 260w
No comments:
Post a Comment